EN tabletop card reader

Preamble

In Autopoll it is possible to configure a tabletop card reading device which is already connected to the computer on which Autopoll is running. With that configuration it is possible to import the card identification (PAN) directly from the card when entering a new card. No manually input of the PAN required.

It is recommended to configure a tabletop card reading device in corporation with the Autopoll hotline. The technical basic data/information like the serial port number, the Baud rate and some testing cards should be prepared and at hand.

Parameter

Open the corresponding parameters over Settings-Parameter.

Baud: the (Baud) rate with which the tabletop card reading device is communicating with the computer

Comport: the serial port of the computer to which the tabletop card reading device is being connected to. With 'K' a reading device integrated into a keyboard is being addressed.

If required the old parameter "autopoll.ausweise.proximity.oldversion" can be activated and used. This parameter activates a technical outdated mode to communicate with older tabletop card reading devices. (downward compatibility)

Conversion

Sollte mit den o.g. Parametern nicht das gewünschte Ergebnis (die gewünschte Ausweiskennung) erzielt werden können, gibt es in den Ausweisarten noch die Möglichkeit die Ausweiskennung weiter umzubauen. Z.B. Ergänzung einer Luhn-Prüfziffer oder mit 0 die Ausweiskennung auffüllen o.Ä.

Spätestens an dieser Stelle sollte Kontakt mit der Autopoll-Hotline aufgenommen werden.

Über Einstellungen-Ausweisarten, die betroffene, aktive Ausweisart öffnen.

Testing / enter new card

To test the above mentioned parameters and above mentioned conversions during the installation or by entering a new card, proceed normally when entering a new card. Open data-cards-single cards (or the corresponding card type), press the button "new" card, put the card on the tabletop card reading device and press the button. The result should be displayed in the field "PAN".