EN gauging points: Unterschied zwischen den Versionen
| Zeile 20: | Zeile 20: | ||
{{clr}} | {{clr}} | ||
===Master files=== | ===Master files=== | ||
[[Datei:Peiltabelle_3_EN.PNG| | [[Datei:Peiltabelle_3_EN.PNG|360px|top|left]] | ||
'''Desc.:''' Name of the probe table/tank type. It is recommended to use the name and the volume of the used tank in which the probe is being installed. | '''Desc.:''' Name of the probe table/tank type. It is recommended to use the name and the volume of the used tank in which the probe is being installed. | ||
Version vom 8. März 2019, 11:55 Uhr
IN ARBEIT
Preamble
Kommt eine Peilsonde in den Tanks zum Einsatz, egal ob die Peilsonde über den Tankautomaten oder direkt als Tankautomat in Autopoll abgerufen werden soll, muss eine Peiltabelle angelegt und danach bei den betroffenen Tanks als "Tanktyp" eingestellt werden. Bei einigen Tankautomaten gibt es vorkonfektionierte Peiltabellen. Die Meisten sind in Autopoll bereits vorgegeben. Bei diesen vorkonfektionierten Peiltabellen werden keine Messpunkte an den Tankautomaten übergeben, sondern nur der definierte Buchstabe bzw. die definierte Zahl.
Menu call up
The gauging points administration is being opened over Settings-Gauging points.
Tank types list
The meaning of each icon 
is being explained under general handling.
Tank type administration
Master files
Desc.: Name of the probe table/tank type. It is recommended to use the name and the volume of the used tank in which the probe is being installed.
Type: The defined letter or defined number when using an at the card reader pre-defined probe table/tank type. 0 when using a probe table/tank type with manually recorded gauging points.
Gauging points: Selection of the number of gauging points. There is no need to record gauging points when pre-defined probe tables/tank types are being used.
Import Import of the gauging points values with an ASCII textfile
Export Export of the gauging points values into an ASCII textfile
The ASCII textfile has the same format/structure for the import and export:
- one row per gauging point
- the values in the import file have to be in increasing order
- value "mm" followed by a blank followed by the value "Liters"
Gauging points
Normally a probe table of the installed tank of the tank manufacturer exists or is available. This list contains 200 to 250 gauging points. The values indicate on the left side the level of the liquid in "mm" or "cm" and on the right side the corresponding volume. Depending on whether 32 or 64 values have been selected, the corresponding number of values have to be taken from that list and recorded in Autopoll. It is recommended to take a cross section of the whole probe table, that means not only values from the start or end of the list, but from every section of the probe table.
Tanks
If the probe table/tank type is being assigned to one or more tanks, then the display shows to which tanks it is assigned to.
Reports Quick access to the inventories reports inventory list and volume control